SPARKIESdown under
  1. Home
  2. Know-how
  3. Switchboard upgrades

Switchboard

Switchboard upgrades: old fuses, new rules

A switchboard upgrade replaces rewireable fuses and old gear with circuit breakers and safety switches. It is main switchboard work, which puts it at the regulated end of the trade. In Victoria it must be inspected by an independent inspector before it is switched on, and in every state it ends with a certificate.

How to tell your board is old

Open the meter box and look. Queensland's Electrical Safety Office describes the classic sign: semi-enclosed rewireable fuses, which are ceramic plug-in units with a length of fuse wire held between two screws. When one blows, someone has to rewire it with the correct rated wire.

That last part is where old boards turn dangerous. The same page warns never to use oversize fuse wire, because it can damage the installation wiring or start a fire. A fuse "fixed" with thicker wire, or a bit of whatever was in the shed, no longer protects anything.

The second sign is what is missing. If nothing on the board has a T or Test button, you have no safety switches. Fuses and breakers look after cables. They do not look after you. The difference is covered in safety switches and RCD rules.

The age of the house matters too

Energy Safe Victoria says a home built before the 1980s should have its wiring checked by a licensed electrical inspector or registered electrical contractor before you move in, and that any house built more than 30 years ago should have the wiring checked. Its reasoning: Victorian fire brigades respond to more than 300 domestic electrical fires each year, many caused by old wiring that has degraded or cannot cope with modern electrical loads.

A new board on rotten cable is half a job. A good sparky will look at both.

What triggers an upgrade

  • Rewireable fuses, or a board with no safety switches
  • A sale or new lease in Queensland or Western Australia, where safety switch rules bite
  • Adding solar, a battery or an EV charger, any of which can need space and capacity the old board lacks
  • Breakers or fuses that trip repeatedly

On that last one, Queensland's advice for a fuse that blows again with the appliance unplugged is that the fault may be in the wiring, and it is time to call a licensed electrician.

The paperwork is heavier than for a power point

Switchboard work sits in the higher category in the states that grade electrical jobs.

Victoria. The main switchboard, consumer mains, meter box and main earthing system are prescribed work. An independent Licensed Electrical Inspector must inspect before the installation is turned on or left on, and you receive a prescribed Certificate of Electrical Safety.

Northern Territory. Replacing switchboards, or protection and control devices in a switchboard, is listed among the work that requires a certificate of compliance.

Western Australia. The contractor lodges a Notice of Completion within three days and gives you an electrical safety certificate within 28 days. See the WA page.

NSW. Work on a switchboard is followed by a Certificate of Compliance for Electrical Work lodged through the eCert portal. See the NSW page.

Questions to put to the sparky

  1. Will every circuit end up on a safety switch, or only some?
  2. Does the quote include any work on the mains or the meter box, and who arranges the inspection if one is needed?
  3. Is the wiring behind the board in fit condition, and did you check it?
  4. Which certificate will I get, and when?

Expect the power to be off for part of the day. Charge the phone first.

Quick answers

Does a switchboard upgrade need an inspection in Victoria?

Yes. Work on the main switchboard is prescribed electrical installation work in Victoria, so an independent Licensed Electrical Inspector must inspect it before it is turned on, and you receive a prescribed Certificate of Electrical Safety.

Are ceramic rewireable fuses illegal?

The regulator pages we read do not say existing rewireable fuses are illegal. They do warn that the fuse wire must be the correct rating, that oversize wire can cause damage or fire, and that fuses do not protect people the way a safety switch does.

Keep reading

Check a licenceAll guides

Written by the Sparkies Down Under editorial desk from the regulator pages listed below, read in November 2026. Rules change. The regulator's current page overrides this one. Method.

Sources

  1. Re-wiring fuses, Electrical Safety Office Queensland. Read November 2026.
  2. Household wiring, Energy Safe Victoria. Read November 2026.
  3. Certificates of Electrical Safety for the community, Energy Safe Victoria. Read November 2026.
  4. Certificate of compliance, NT WorkSafe. Read November 2026.