Fire safety
Smoke alarm laws, state by state
Every Australian home needs working smoke alarms, but the detail changes at each border. Queensland is the strictest: by 1 January 2027 all existing homes must have interconnected photoelectric alarms. Other states set the rule by when the home was built, bought or leased. Anything mains powered is a job for a licensed electrician.
The quick comparison
| State | Core rule | Source |
|---|---|---|
| Queensland | Interconnected photoelectric alarms in all existing homes by 1 January 2027 | Queensland Government |
| NSW | At least one working alarm complying with AS 3786 on each level | NSW Planning |
| Victoria | At least one alarm on each level, and between each sleeping area and the rest of the house | Fire Rescue Victoria |
| South Australia | Type depends on when the home was built or bought; fines of up to $750 | SA.GOV.AU |
| Western Australia | Homes built after 1 May 2015 must have interconnected alarms | DFES |
| Tasmania (rentals) | Mains powered, or a 10 year non-replaceable battery | Consumer Affairs Tasmania |
We have not listed the ACT or the Northern Territory because we could not open an official page that set out their rules. Check with the local fire service before relying on anyone's summary, ours included.
Queensland's 2027 deadline
This is the one catching people out. By 1 January 2027, all existing private homes, townhouses, units and manufactured homes in Queensland must have interconnected photoelectric smoke alarms. Registered caravans and motorhomes need a photoelectric alarm too.
To comply, each alarm must:
- be photoelectric
- be interconnected with every other smoke alarm in the dwelling, so all of them go off together
- comply with Australian Standard AS 3786:2014, which is marked on the body of the alarm
- not contain an ionisation sensor
Interconnection can be done by cable or wirelessly depending on the product. If the alarms are hardwired to mains power, the wiring belongs to a licensed electrician.
New South Wales
Smoke alarms became mandatory in certain new NSW buildings in the early 1990s, and in 2006 the rule was expanded to all existing homes. Owners must ensure at least one working alarm complying with AS 3786 is installed on each level.
Victoria
By law at least one smoke alarm goes on each level of a house, and that includes units, flats and townhouses. Alarms must also sit between each bedroom area and the rest of the home, and must meet AS 3786. Fire Rescue Victoria draws a line at 1 August 1997: homes constructed, largely renovated or extended after that date need hard wired alarms on 240 volt mains power with a back-up battery.
South Australia
SA dates the obligation from the purchase:
- Bought before 1 February 1998: a replaceable battery powered alarm is the minimum.
- Bought from 1 February 1998: you have six months from the title transfer to fit either a 240 volt mains powered alarm or a 10 year life, non-replaceable, non-removable battery alarm.
- Built from 1 January 1995: the building code requires a 240 volt mains powered alarm.
New dwellings, additions and extensions must interconnect their alarms.
Western Australia
The Department of Fire and Emergency Services recommends mains powered photoelectric alarms. Its page is firm on who does the wiring: only a licensed electrician can connect or disconnect a mains powered smoke alarm. All smoke alarms should be replaced every 10 years because their sensitivity drops with age.
Tasmanian rentals
Under the Residential Tenancy Act 1997, owners of rented homes must install and maintain smoke alarms that are either permanently connected to the power supply, with a back-up supply, or powered by a 10 year non-replaceable battery. An alarm with a replaceable battery does not comply in a rental.
Where the sparky comes in
Battery alarms you can fit yourself. Mains powered alarms, hardwired interconnection and anything that involves a cable in the ceiling are electrical work. Before anyone climbs up there, read roof space safety.
Quick answers
When is the Queensland smoke alarm deadline?
1 January 2027. By then all existing private homes, townhouses, units and manufactured homes in Queensland must have interconnected photoelectric smoke alarms.
Are ionisation smoke alarms allowed in Queensland?
Not for compliance with the Queensland smoke alarm laws. Compliant alarms must be photoelectric and must not contain an ionisation sensor.
How long do I have to fit smoke alarms after buying a house in South Australia?
Six months from the date the title is transferred, for properties bought from 1 February 1998. The alarm can be 240 volt mains powered or a 10 year non-replaceable battery type.
Keep reading
- SolarSolar and battery installers: licence and accreditation
- EV chargingEV charger installation: who can do it
- LicensingElectrician vs electrical contractor: the difference
Written by the Sparkies Down Under editorial desk from the regulator pages listed below, read in November 2026. Rules change. The regulator's current page overrides this one. Method.
Sources
- Smoke alarms, Queensland Government. Read November 2026.
- Smoke alarms, NSW Department of Planning. Read November 2026.
- Smoke alarms, Fire Rescue Victoria. Read November 2026.
- Smoke alarms, SA.GOV.AU. Read November 2026.
- Smoke alarms, Department of Fire and Emergency Services WA. Read November 2026.
- Smoke alarms in rental properties, Consumer Affairs Tasmania. Read November 2026.