SPARKIESdown under
  1. Home
  2. Know-how
  3. EV charger installation

EV charging

Getting an EV charger installed at home

A wall-mounted EV charger wired into your switchboard is electrical installation work, so in every state it has to be installed by a licensed electrician working for a licensed or registered electrical contractor. You should get the same certificate as for any other new circuit. The charger that plugs into an ordinary power point is an appliance and needs no installer.

Plug-in or hardwired

The law does not have a special category called "EV charger". It has a line between appliances and installations, and a charger can sit on either side.

The portable lead that comes with many cars plugs into a normal socket. NSW law, for one, excludes anything connected beyond a socket outlet from the definition of an electrical installation. Using it is like using any other appliance.

A wall box is different. It is fixed, it gets its own circuit from the switchboard, and wiring that circuit is electrical work in every jurisdiction. Queensland's definition covers "installing, testing, maintaining, repairing, altering, removing, or replacing" electrical equipment, and notes that it is legal to buy an appliance that needs to be hard-wired but it must be connected by a licensed electrician.

So: buy the charger wherever you like. Do not wire it in.

We are not quoting amps and kilowatts

Charger ratings, cable sizes and what your street supply can handle depend on your house and your local distributor. We have not found a regulator page that sets one national figure, so we give none. Your electrician works it out from the Wiring Rules and the distributor's requirements. If someone quotes without asking about your existing board and the other large loads in the house, get another quote.

The job often grows

A new high-load circuit asks questions of an old installation. Three things commonly ride along with a charger:

  • Space and protection in the board. The new circuit needs its own protective device. A board full of rewireable fuses will probably need work first. See switchboard upgrades.
  • The mains. If the supply to the house needs upgrading, that is a bigger job with its own approvals.
  • Solar and batteries. People often want the charger to talk to the solar. That brings in the accreditation rules covered in solar and battery installers.

Which certificate you get

A charger circuit is new installation work, so the usual state document applies.

StateDocument
NSWCertificate of Compliance for Electrical Work
VictoriaCertificate of Electrical Safety
QueenslandCertificate of testing and safety, or testing and compliance
South AustraliaElectronic certificate of compliance
Western AustraliaElectrical safety certificate
TasmaniaRecord of electrical work, and a Certificate of Electrical Compliance if notifiable
ACTCertificate of Electrical Safety
Northern TerritoryCertificate of compliance

In Victoria, ask your contractor which kind of certificate the job needs. Work on the main switchboard or consumer mains is prescribed and needs an independent inspection before it is turned on, and a charger job sometimes includes that. Timeframes for each state are in certificates of electrical safety.

Renters and apartments

A wall box is a fixed alteration to someone's building. Renters should expect to need the owner's agreement. In an apartment block the cable to a car space commonly runs through shared areas, so expect the owners corporation to have a say, and expect questions about how much supply the building has to spare. Start those conversations before you pay a deposit on a charger.

Before you sign

  1. Contractor licence checked on the official register.
  2. Written scope: charger, new circuit, any board or mains work.
  3. Confirmation of which certificate you will receive.
  4. Who deals with the distributor if an application is needed.

Quick answers

Can I install my own EV wall charger?

No. Wiring a fixed charger into your switchboard is electrical installation work and must be done by a licensed electrician. You can buy the unit yourself, but it must be connected by a licensed electrician.

Do I need an electrician to use the portable charger that came with my car?

Not to use it. A charger that plugs into an existing socket outlet is an appliance. If you want a new or dedicated socket installed for it, that new socket is electrical work.

Keep reading

Check a licenceAll guides

Written by the Sparkies Down Under editorial desk from the regulator pages listed below, read in November 2026. Rules change. The regulator's current page overrides this one. Method.

Sources

  1. Electrical work: licences and certificates, NSW Government. Read November 2026.
  2. Don't do your own electrical work, Electrical Safety Office Queensland. Read November 2026.
  3. Certificates of Electrical Safety for the community, Energy Safe Victoria. Read November 2026.